Thermco Foam Insulation Installation

Easy, Non-Disruptive Installation

In addition to superior performance and cost effectiveness, Thermco Foam is easy for a certified, trained technician to install. There are no bags, bundles or pallets to handle - and no material blowing around. The product is mixed on-site and is dispersed by a pumping system in the installer's truck. The following steps summarize the ease of this process.

1) Planning and Prep Your local certified Thermco representative will carefully examine the structure to be insulated prior to beginning the project. They will also coordinate scheduling with both the masonry and general contractors.			4) Filling A certified installer pumps in the foam under mild pressure until it begins to appear at adjacent holes, insuring a complete fill. In multi-story applications, Thermco Foam will be installed every fourteen feet of wall height.

2) Drilling Once the block pattern has been determined, the Thermco installer will carefully drill holes in the appropriate seams to insure proper penetration and flow of the foam during installation. Thermco Foam can also be top-filled if drilling holes is undesirable.			5) Clean-Up The nature of Thermco Foam allows for quick and complete clean-up of the small tails that back up out of the installation holes. These small bits of foam are welcome evidence of a complete fill.

3) On-Site Quality Control An experienced installation technician is required to check the texture, weight, and density of Thermco Foam to ensure top quality and performance. This test is repeated randomly throughout the process as an ongoing quality control measure.			6) Patching Once the foam has cured, the holes are carefully patched with tuck point tools and mortar. The wall can then be painted, covered, or left as is.

There is simply no better or more efficient way to insulate spaces in masonry construction
than with Thermco Foam Insulation.